Encore electronic ENUTV-DVB-S - Manual (Page 12)

ENUTV-DVB-S User’s Guide -
12
There are many different satellites, load a default satellite in the transponder list. Click [Load]
button under the satellite item. The following picture will display on the screen. Or, you can
choose the satellite you need.
a) [Name]
Press to display the drop-down list, and select the desired satellite from the list. Input the satellite
name you want to add.
b) [DiSEqC]
The item is used to select the DiSEqC port. This is compatible with the DiSEqC 1.0 protocol.
c) [Dual Oscillator]
The Low Noise Block (LNB) is a combination of a low noise amplifier (LNA) and down converter
which built them into one device. As one LNB has limited bandwidth, so we need two LNBs, low
and high LNB. Select C band, Single or Double according to the type of dish you have. If you have
select C Band, the frequency values of low LNB is 5150. If you have single LNB mode, the
frequency values of low LNB is 11300. If you have dual LNB mode, to change the default value,
click in the [Low LNB] and [High LNB], select needed frequencies from them. In this case, [22K]
is inactive.
d) [ToneBurst]
Select [OFF] or [ON] in this column.