Enterasys Networks 802.11 - Manual (Page 27)

1-11
LAN-to-LAN Configuration
Figure 1-4 provides an example of two Central APs in the same Point-to-Multipoint
configuration. In this configuration, six APs are configured to communicate with the same
Central AP. You can configure one or more of those six APs as a Central AP to
communicate with up to five additional APs. If using an Access Point 2000, this
configuration requires the Wireless Relay parameter to be enabled.
Figure 1-4: Point-to-Multipoint-to-Multipoint Configuration
Omni-Directional
Antenna
A5 Endpoint Mode
A3
Endpoint Mode
A1 Endpoint Mode
Building A
Multipoint Mode (Central AP)
Area 2
Area 1
A2 Endpoint Mode
A4 Endpoint Mode
B5 Endpoint Mode
B2
Endpoint Mode
B3 Endpoint Mode
B4
Endpoint Mode
Building B
Multipoint Mode
(Central AP)
B1 Endpoint Mode
Omni-Directional
Antenna
A5 Endpoint Mode
A3
Endpoint Mode
A1 Endpoint Mode
Building A
Multipoint Mode (Central AP)
A2 Endpoint Mode
A4 Endpoint Mode
Building B
Multipoint Mode
(Central AP)
A4 Endpoint Mode
B5 Endpoint Mode
B2
Endpoint Mode
B3 Endpoint Mode
B4
Endpoint Mode
Building B
Multipoint Mode
(Central AP)
B1 Endpoint Mode
A4 Endpoint Mode
Building B
Multipoint Mode
(Central AP)