EAW MQV2364e - Manual

SPECIFICATIONS MQV2364e
FEATURES
PHYSICAL
One Main Street, Whitinsville, MA 01588 508 234 6158 Toll Free 800 992 5013 FAX 508 234 8251 [email protected] www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. MQV2364e/0002692/002/2 pp October 2003 Printed in USA
FEATURES
DESCRIPTION
PERFORMANCE
APPLICATION
• Full-range, 3-way system
• 2x 15-in LF; 2x 10-in horn-loaded MF; 2-in exit
Neodymium HF
• 60° x 40° beamwidth
• Horizontally configured to create vertical arrays
A 3-way, full-range system in a vented trapezoidal enclosure.
Includes dual, slot-loaded 15-in woofers, dual, horn-loaded
10-in MF cones with Radial Phase Plug™, and a 2-in exit/3-in
diaphragm Neodymium compression driver. The MF and HF
horns provide a nominal 60° x 40° beamwidth. An internal
passive crossover with jumpers on the input panel allows user
selection of either bi-amplified or passive operation. In either
case digital signal processing is required to achieve specified
performance. The enclosure features a comprehensive system
of 3/8”-16 threaded suspension points.
The MQV2364e combines the MQ Series LF/MF/HF components
into a full-range, single-enclosure loudspeaker. It is horizon-
tally configured for arraying in vertical columns. This arrange-
ment is typically used in sports arenas and other venues where
the array must address wide, vertical audience angles. Dual LF
and MF components produce greater output than MQV1300
series products. The MF/HF horns in the MQV2364e feature a
rigid but well-damped construction using wood veneer backed
by structural foam. A no-compromise design means the mid
and high frequency horns are truly large enough to provide
optimal pattern control throughout each passband.
Application Usage: Install
Houses of Worship Auditoriums Theatres
Performing Arts Centers Arenas Stadiums
Frequency Response
±3 dB 72 Hz to 15 kHz
-10 dB 50 Hz
Axial Sensitivity (dB SPL, 1 Watt @ 1m)
LF 97
MF/HF 108
MF 110
HF 108
Impedance (Ohms)
LF 4
MF/HF 4
MF 4
HF 8
Power Handling, AES Standard (Watts)
LF 1200
MF/HF 800
MF 800
HF 150
Calculated Maximum Output (dB SPL @ 1m)
LF Peak/Long Term 134/128
MF/HF Peak/Long Term 140/134
MF Peak/Long Term 142/136
HF Peak/Long Term 136/130
Nominal Coverage Angle, -6 dB Points (degrees)
Horizontal 60
Vertical 40
Recommended High-Pass Frequency
24 dB/Octave 50 Hz
LF Subsystem 2x 15-in, vented
MF Subsystem 2x 10-in horn loaded cone,
Radial Phase Plug™
HF Subsystem 1x 2-in exit/3-in voice coil com
pression driver on constant
directivity horn
Configuration Three-way, full range
Powering Bi- or Tri-amplified
Enclosure Materials Exterior grade Baltic birch plywood
Finish Wear-resistant textured black paint
Connectors Terminal barrier strip
Suspension Hardware 16x 3/8”-16 threaded mounting
points (4 each on top, bottom
and sides)
Grille Powder coated perforated steel
Dimensions inches millimeters
Height (front) 36.71 932
Height (rear) 25.36 644
Width 56.25 1429
Depth 25.59 650
Trapezoid Angle 12.5 Degrees per Side
Weights pounds kilograms
Net Weight 300 136.4
Shipping Weight 330 150.0