Electrolux EWF 127112 W - Manual (Page 11)

If you have already pressed the
Start/Pause button, and you wish to
cancel the delay time, proceed as
follows:
●
set the washing machine to PAUSE
by pressing the Start/Pause button;
●
press the Delay Start button once, the
light relevant to the selected delay
goes off.
●
press the Start/Pause button again to
start the programme.
Important!
●
The selected delay can be changed
only after selecting the washing
programme again.
●
The door will be locked throughout
the delay time. If you need to open
the door, you must first set the
washing machine to PAUSE by
pressing the Start/Pause button and
then wait about 2 minutes. After you
have closed the door, press the
Start/Pause button again.
The Delay Start can not be selected
with Spin and Drain
programmes.
Programme progress display
By selecting the wash programme, the
“wash” pilot lights comes on.
When the pilot light “wash” comes on
this means that the machine is
performing the washing cycle. If you
have selected the “prewash”
function, this light will be on
during the prewash phase too.
The “door” pilot light indicates if
the door can be opened:
●
on: the door cannot be opened.
The appliance is running.
●
light off: the door can be opened.
The washing programme is finished.
●
flashing light: the door is opening.
When the programme has finished, the
“End” pilot light comes on.
Altering an option or a running
programme
It is possible to change any option
before the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing
the “Start/Pause” button.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to “O” and then to the new
programme position. The washing water in
the tub will not emptied out. Start the new
programme by depressing the “start
pause” button again.
Interrupting a programme
Depress the “start pause” button to
interrupt a programme which is running,
the corresponding light starts to flash.
Depress the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to
“O” to cancel
a programme which is running. Now
you can select a new programme.
Opening the door after the
programme has started
First set the machine to pause by
pressing the “start pause” button.
If the “door” light flashes and
after 2 minutes goes off, the door can
be opened.
If the “door” light does not switch
off, this means that the machine is
already heating, that the water level is
above the bottom edge of the door or
that the drum is turning.
use electrolux 37
126.2931.37…EWF 127112 W:- 12/07/10 16:46 Página 37