Electrolux EWF 127112 W - Manual (Page 26)

52 electrolux installation
Levelling
Level the appliance by loosening or
tightening the feet. Once in the right
position fix the feet by pushing the nuts
against the base of the case. Accurate
levelling will prevent vibration, noise and
displacement of the appliance during
operation.
Some vibration is inevitable, especially if
placed on a wooden floor. Wooden
floors are particularly susceptible to
vibrations. If possible always place the
appliance on a solid floor.
IMPORTANT:
The distance from the floor to the
highest part of the hose should be
between 60 to 90 cm. (It is advised to
be between 60 and 70 cm). The hose
must not be bent nor twisted to avoid
clogging. Should a prolongation of the
discharging hose be unavoidable this
must never surpass 1.5 m and must be
of the same diameter as the original
hose.
Make sure the hoses are not too tense.
Electrical connection
This machine is designed to operate on
a 230 V, single-phase, 50 Hz supply.
Check that your domestic electrical
installation can take the maximum load
required (2.1 kW), also taking into
account any other appliances in use.
The applicable rules for electrical
security require an adequate
earthing. The plug of the appliance
is provided with such a device.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the above
safety precaution. Should the appliance
power supply cable need to be
replaced, this should be carried out by
our Service Centre.
Please ensure that when the appliance is
installed the power supply cable is easily
accessible.
126.2931.37…EWF 127112 W:- 12/07/10 16:46 Página 52