Electrolux EWT606 - Manual (Page 22)

Troubleshooting
Problem Possible causes (digital display code) What to do
Clothes still dirty after
wash program. Not enough or no detergent. Check detergent use and rewash clothes.
Too many clothes in load. Remove some clothes and rewash.
Incorrect selections for Program, Dirt
Level or water Temp. Reselect settings.
Incorrect water level selected. Use auto sensing water level and rewash clothes.
Clothes still wet or
sudsy after wash
program Poor rinsing and spin due to excessive
suds. (
)
In future use less detergent & ONLY use a low sudsing,
front load washer detergent in this machine, such as Cold
Power for Front Loaders and High Efficiency Top Loaders or
detergent labelled “Matic”.
Scraping noise on spin. "RAåWIREåORåOTHERåTHINåITEMåCAUGHTå
between inner and outer washbowls. If item is visible, remove with pliers.
Use wash bag in future.
Humming, clicking
and other intermittent
noises. "OWLåROTATIONåATåSTARTåOFåWASH Normal noise.
7ATERåmOWCASCADEåNOISEåFROMå
recirculated water entering washbowl
Normal noise that may be heard during water recirculation
when pump is ON.
Lid will not open Machine is at a spin stage and
‘Lid Locked’ light is ON If you want to access the bowl, wait until stage is complete
and light is OFF. Then you can open the lid.
At end of wash. Machine is finishing final
spin & the lid lock release stage. 7AITåAåSHORTåWHILEåUNTILå@,IDå,OCKEDåLIGHTåISå/&&
Lid may be stuck in the locked position. If ‘Lid Locked’ light is OFF, press Power to turn off machine,
then press Power again. If lid still will not open you should
call Service.
18 troubleshooting electrolux water aid washing machine