Emerson HKTV13 - Manual (Page 10)

Connecting an Antenna or Cable to Your TV
Connecting Rod Antenna (included)
Install Rod Antenna on top rear of cabinet and connect other end to the antenna terminal.
Your TV will provide you with the best performance if you connect it to an external antenna or cable sys-
tem. Follow the directions below make this connection. Please note that you will normally only have to
make one of the connections shown below, not all of them.
All connections will be made to the antenna terminal on the back of your TV. For help in locating the
antenna terminal, see “Your TV's Back Panel” on page 5.
Connecting an External Antenna
If your antenna ends in a single coaxial lead, simply
press or screw the cable onto the antenna terminal on the
back of your TV.
If your antenna ends in a pair of 300 ohm twin leads , you must use a 300-ohm/75-ohm
adapter(included). Place the leads underneath the screws on the adapter, tighten the screws, then press the
adapter onto the antenna terminal on the back of the TV.
8
C H A P T E R 2
Chapter 2 : Connecting an Antenna or Cable to Your TV