Emerson HKTV13 - Manual (Page 16)

Changing the TV's Input
Normally, your TV displays the signal coming through the antenna terminal. However, If you’ve
connected another component to your TV(such as a VCR) using the Video/Audio input, you will
want to be able to view the signal from the component.
To do this, you will need to switch from the ‘TV’ input to the ‘ Line ‘ Input.
Simply press "INPUT" button on remote control. Or follow steps as below.
1 On "MENU" mode, select "SETUP" and enter "Set-Up" menu.
2 Use the VCHW buttons to select “ Input “.
3 Press the CVOLB buttons to change from ‘TV’ to ‘ Line ‘.
4 Wait 10 seconds, or press the MENU button to return to normal TV viewing.
If two separate AV components are connected at front and rear VIDEO IN/AUDIO IN jacks, the
"SOURCE" from front inputs takes priority. To operate through rear input, make sure to disconnect
front inputs.
Select
Set-Up
Language : English
Reception : Air
Memorize Channels
Add/Delete Channels
Input :
TV
Adjust Next
1
Select
Set-Up
Language : English
Input :
Line
Adjust Next
3
Select
Set-Up
Language : English
Reception : Air
Memorize Channels
Add/Delete Channels
Input :
TV
Adjust Next
2
14 Chapter 3 : Operating Your TV