Electrolux T37400 - Manual (Page 17)

To change a programme already in progress, turn the selector dial to
RESET position, select the new programme and then depress START but-
ton.
Important! If the drying programme has to be stopped before it reach-
es the end, we recommend that you turn the programme selector dial
to position COOLING and wait until the end of this phase before remov-
ing the laundry. This will avoid a build-up of heat inside the appliance.
Remove or add laundry
It is possible to interrupt the drying cycle at any time in order to remove
or add laundry.
Open the door.
Caution! Laundry and drum can be hot.
Remove or add laundry.
Close the door and press START button to continue the drying cycle.
End of drying cycle
A cooling phase is performed before the end of the drying cycle: the
heat is cut off during this phase. After the cooling phase, it is possible
to remove the laundry from the dryer.
Immediately open the door and remove the laundry.
Anti-creasing phase
If you do not remove the laundry at the end of the programme, the
machine will automatically carry out an Anti-crease phase for approx
30 mins. During this period the drum will rotate at regular intervals to
avoid creasing and the buzzer will sound for 1 second every 10 seconds,
unless you have depressed the NO BUZZER button. The lights END and
ANTI-CREASING PHASE will flash alternatively.
Switch the tumble dryer off
Depress ON/OFF button. Pull out the plug.
Clean the filters
To ensure free circulation of air during the drying cycle, the fluff fil-
ters must be cleaned after each drying cycle, before removing the
laundry.
17
Drying
125980461_1.qxp 2004-10-11 11:31 Page 17