Emerson Process Management Micro Motion 3500 Transmitter - Manual (Page 7)

6
Figure 3. Positions of guide rails and wiring connectors
STEP 3. Installing the Model 3300/3500 in the rack
1. Align the Model 3300/3500 with the guide rails.
2. Slide the Model 3300/3500 into the rack. Make sure the pins on the
back panel make contact with the wiring connectors.
3. Tighten the supplied captive screws to secure the front panel of the
Model 3300/3500 to the guide rails.
Power supply wiring
connector is 25 HP (25 TE)
from neighboring unit or
from edge of rack
Input/output wiring
connector is 4 HP (4 TE)
from neighboring unit or
from edge of rack
Keyed sensor wiring
connector is 16 HP (16 TE)
from neighboring unit or from
edge of rack
Keys on sensor
wiring connector
M2.5x8
Install screws and connectors from front of
rack.
•
Model 3500 has six M2.5x8 screws
and three connectors.
• Model 3300 has four M2.5x8 screws
and two connectors.
Front
Guide rail centers should be 27 HP (27 TE) apart;
for example, 1 HP (1 TE) and 28 HP (28 TE)
Back