Crivit 2-PERSONEN-KAJAK - Manual (Page 8)

10
2 . To deflate the side chambers / screw the
valves completely from their base mountings .
Kit bag
A kit bag is included with this article in which
the kayak is stowed away for transport and
storage . In order to close this, please use the
200cm rope . The kit bag is also useful when
afloat for the splash-proof safekeeping of provisi-
ons, clothes etc . Please remember that this bag is
not watertight . For this reason, do not store sen-
sitive objects in it, for example, cameras . For use
aboard it is advisable to remove the rope and to
flatten and roll up the upper end, closing it when
necessary with the hook and loop fastener .
Storage bag
A splash-proof storage bag is also included
which can be attached to the back of the front
seat using the hook and loop fastener . Small
objects can be stowed away here to keep them
dry but please remember that this bag too is
not completely watertight . Please do not store
sensitive objects here .
Transport
Always transport the kayak with two adults and
use the carrying straps at the front and back
of the craft .
Care / Maintenance / Storage
WARNING!
Only use care products that do not
contain traces of acids or petroleum and
never use silicone-based products.
1 . Clean your kayak thoroughly after every use
with fresh water and mild soap to remove salt
crystals, sandy granules and other small dirt
particles . Leave it to dry completely .
2 . Lay both of the upper side pipes into the
inside of the kayak and fold them together
carefully .
3 . Store your kayak in a clean and dry place
away from direct sunlight and somewhere
where there are no great temperature
fluctuations . Pay attention to the fact, that the
kayak is not wrinkled but lays flat, and keep
well out of the reach of rodents .
Repairs
WARNING!
You should not attempt to repair large
damaged sections by yourself.
You can repair small areas with the enclosed
repair kit .
1 . Deflate the kayak completely and clean the
area to be repaired with an alcohol-based
solution . Roughen up the damaged area
surrounding the hole or tear with a fine sand
paper .
2 . Cut a patch to cover the damaged area . The
patch should overlap the damaged area by at
least 1 .25cm on all sides .
3 . Apply the glue to the kayak as well as to the
patch . Allow to dry for approx . 3 minutes .
4 . Press the patch down firmly using a soft
object . Make sure that you are working on a
flat, even surface . Remove any air bubbles
with a rounded object, gently pushing the
bubbles in an outward direction .
5 . Always wait at least 12 hours after a repair
before pumping up the kayak once again .
Disposal
Please dispose of the product and packaging in
an environmentally friendly manner, separating
different materials for recycling as required! Dis-
pose of this item through an authorised disposal
company or through your local waste disposal
facilities - ask your local authority for information
if further guidance is required . Ensure that you
comply with all regulations currently in force .
GB