Crivit CEB 1400 A1 - Manual (Page 51)

47 CEB 1400 A1
GB
Handling and operation
In this section you receive important information for the handling
and operation of the appliance.
Switching the insoles on / off /
selecting the heat setting
♦ Place the trimmed insoles in your shoes with the printed
side down and run the cable upward along the heel.
♦ Attach the battery packs using the straps to your shoes and
connect the connector plug of the insoles with the con-
nection sockets of the battery pack (see Figure 1).
Fig. 1
IMPORTANT
► When wearing low shoes, tuck the excess cable into your
socks. The cable must not drag on the ground while walking!
♦ Press the function switch to switch the battery pack on.
The battery pack switches itself on with the heat level I and
the function indicator glows green.
♦ By pressing the function switch once again, the heat level II
can be switched on. The function indicator glows red.
♦ To switch the battery pack off , press the function switch
once more. The function indicator goes out.
NOTE
► For quick warming, it is recommended to initially select the
the heat level II. It can later, if necessary, be turned down to
the lower heating level.
► When the battery pack is discharged, the function indica-
tor switches off and the insole is no longer heated.
IB_100082_CEB1400A1_LB1.indb 47 IB_100082_CEB1400A1_LB1.indb 47 20.06.14 10:38 20.06.14 10:38