Ericsson ATSC Broadcast Receiver RX8320 - Manual (Page 12)

Quick Start Guide: Connect-Power-Configure
• The unit will automatically decode the first video component that it finds within
the selected service.
• An alternative video component may be selected from the service tab on the
Web Control interface.
• If the incoming video is successfully decoded then the status OK should be
displayed on the appropriate page.
• Successfully decoded High Definition video will be output from the connector
marked Video Component.
• Successfully decoded Standard Definition video will be output from the
connector marked CVBS.
3.6 Configuring the Audio Outputs
When configuring the Audio Outputs the following points should be observed:
• The unit will automatically decode the first two audio components that it finds
within the selected service.
• Alternative audio components may be selected from the service tab on the Web
Control interface.
3.7 Configuring for Single-service Decryption
When configuring for Single-service Decryption the following points should be
observed:
• If the service selected for video decode contains encrypted components these
components will automatically be decrypted by the unit.
• The outgoing feed from the unit will contain these decrypted components
providing the TS feed on the Output tab on the Web Control interface is set to
descrambled.
3.8 Configuring for Multi-service Decryption
When configuring for Multi-service Decryption the following points should be
observed:
• With Director Multi-service Decryption, when a feed containing more than one
encrypted service is applied to the unit, the first 24 services detected are
automatically decrypted. A list of these services can be found in the service
table on Services Menu.
• With Common Interface Multi-service Decryption, when a feed with more than
one encrypted service is applied to the unit, the user may choose how it is
decrypted using the Maximum CAM Services, Maximum CAM Components
EN/LZT 790 0008/2 R1A 2011-03-30 12 (36)