Elite Screens 235 - Manual (Page 7)

7
Rev.051811‐AS
www.elitescreens.com [email protected]
Attach the Fix Plates
1. Make sure that the material and frame are both lying face down on a clean, dry and non‐abrasive
surface.
2. Center the material inside of the frame
Note: The material was made smaller than the frame in order to be stretched to create a sufficient amount of
tension .
3. Start attaching the Fix Plates in the center of each horizontal frame piece (1), then in the center of
each vertical frame piece (2). (see fig.7)
Note: Follow these instructions to make sure the material is properly fixed in the center position of the frame.
After attaching the fix plates in sequence #2 (vertical sides), remove the fix plates in sequence #1 (horizontal
pieces) and re‐attach them again, and also remove the fix plates from sequence # 2, and re‐attach.
4. Follow the suggested numbers 3‐8 to properly attach the fix plates to the frame.
Center Support Bar
1. Insert the Support Joiner into each side of the Center Support Bar.
Support Joiner Center Support Bar
2. Insert the Center Support Bar into the upper top groove of the back frame (not the fix plates insert)
with the bottom end near the approximate center point of the frame and place it in at an angle so
that both ends of the bar are in alignment with the groove (see fig.8).
(Fig. 7)