Miomare LED Washbasin Fitting / LED Bath/Shower Fitting - Manual (Page 6)

6 GB/IE
Introduction
LED Bath / Shower Fitting
Introduction
Congratulations on the purchase of your
new product. You have selected a high
quality product. The assembly and oper-
ating instructions are part of this product. Please
carefully read these assembly instructions / instruc-
tions for use before use and observe all instructions.
These assembly instructions and instructions for use
contains important assembly, set-up and care infor-
mation. Please retain these assembly instructions /
instructions for use and hand them on to any future
owner.
Intended use
The product is only designed to regulate the hot and
cold water flow. For tub installation only. Suitable
for use with all pressure-resistant hot water systems
such as central heating, continuous-flow water heater,
pressure boiler etc. This product is not suitable for
low pressure water heaters or pressure-free small
storage reservoirs, e.g. wood- or coal-burning do-
mestic hot water heaters, oil or gas-fired hot water
heaters, or open electrically heated cylinders. When
in doubt please consult a plumber or heating spe-
cialist. Any use not specified or product modification
is prohibited and will result in damage. Any form of
use other than the stipulated intended purpose can
cause danger to life and cause injury. The product is
for private use only and is not intended for medical
or commercial use. The manufacturer accepts no
responsibility if the intended purpose of this unit is
not adhered to.
Parts description
1 2 S-connectors
2 2 Silencers*
3 2 Covers
4 2 Seals (S-connectors)
5 2 Swivel nuts*
6 Fitting body
7 Diverter*
8 Shower connection*
9 LED cover*
10 Tub mixer*
11 Socket head wrench
12 LED installation wrench
13 Cartridge*
14 Cartridge lock nut*
15 Cartridge cover ring*
16 Handle*
17 Locking screw*
18 Hot / cold plaque*
* prefitted
Technical Data
Swivel nut
(water connections): G ¾“
Shower hose
connection:
G ½“
Flow rate at 3 bar:
Shower connection: approx. 17.7 to 18.8 L / min
Tub mixer:
approx. 8.5 to 9.2 L / min
LED light: approx. < 33°C blue,
approx. 33–43°C green,
approx. > 43°C red
approx. > 53°C flashing red
LED life: approx. 10,000 operating
hours
Temperature sensor
tolerance:
+/- 2°C
Scope of delivery
1 LED tub filling / shower mixer ( 5 – 10 , 13 – 18 )
2 Caps 3
2 S-connectors with silencer ( 1 – 2 )
2 Seals 4
1 Socket head wrench 11
1 LED installation spanner 12
1 Instructions for assembly / operation