Epson EL 486UC - Manual (Page 36)

Setting the Boot Options
When you select
Boot Options from the Main Menu, you see
the Boot Options screen. These options allow you to define the
boot sequence and determine the information you see on the
screen when you start up your system.
The
Disk drive boot sequence option determines the
order in which the computer checks the drives when it looks
for the operating system.
If you select
A: then C:, each time you turn on the
computer, it first tries to load the operating system from drive
A. If drive A doesn’t contain an operating system, the
computer loads it from drive C. If you select
C : then A:, the
computer tries to load the operating system from drive C first.
If drive C doesn’t contain an operating system, the computer
tries to load it from drive A. If you select C : only, the
computer tries to load the operating system from drive C only.
If you
set the Disk drive boot sequence option to
C: only, you can disable the
Floppy seek option so the
system does not try to access the diskette drive at startup.
Disabling the
Floppy seek option decreases the time needed
to boot the system.
The
Display SETUP prompt during POST option allows
y o u t o d i s a b l e t h e m e s s a g e P r e s s < F 2 > t o e n t e r
SETUP
that you see during power-on diagnostics. You may want to
disable this prompt to prevent unauthorized users from seeing
the SETUP prompt. Even when the message is disabled,
however, you can still start SETUP by pressing F2 within the
allowed amount of time.
2-8 Running the SETUP Program