Exmark Operator Controlled Discharge for Walk-Behind Units OCDWB01 - Manual (Page 8)

Setup
Setup
Assembling Discharge
Deflector to OCDWB01
Insert the rod through the first tab on the gate link
frame, discharge deflector, and second tab on the gate
link frame (Figure 2). Orient and install the spring so
that the loop will rest in the notch on the discharge
deflector. Continue to push the rod into the linkage
cover. Orient and install the hairpins into the ends of
the rod as shown in Figure 2.
Figure 2
1. Hairpin 6. Second tab
2. Rod 7. Linkage cover
3. Discharge deflector 8. Spring
4. Gate link frame 9. Notch
5. First tab
Installing OCDWB01 on
Mower Deck
For 32 inch, 36 inch, or Vantage decks: Use a
hammer and chisel to knock out the tab, as shown in
Figure 3, before starting the installation instructions.
Knocking out the tab allows the OCDWB01 frame
to fit properly to these decks.
Figure 3
1. Knock out tab
1. Flip up the existing discharge deflector.
Important: The OCDWB01 comes with its
own discharge deflector. When using the
OCDWB01, Exmark recommends the original
discharge deflector to remain installed on the
unit and in the flipped up position. There are
some instances where the existing discharge
deflector must be removed when installing
the OCDWB01. If the original discharge
deflector is removed during the OCDWB01
installation, retain the discharge deflector
and its hardware for reinstallation once the
OCDWB01 is removed.
2. Install the OCDWB01 assembly by inserting the
mounting pin into the tube welded to the rear
corner of the deck (see Figure 4).
Figure 4
1. Flip up discharge chute 3. OCDWB01 assembly
2. Mounting pin inserted
into deck tube 4. Rotate
3. Pivot the assembly towards the deck. The front
pin should engage into the slot in the deck as
shown in Figure 5.
8