Electrolux ENB 40405 W - Manual (Page 35)

electrolux 35
GB
Place the freezer door on the lower
door retaining pin (f) (Fig. 4).
Open doors and fix the double door
mount with 2 screws (c) on the left-
hand side. Don't forget the plastic
spacer under the door (b) as well. The
edges of the doors must run parallel to
the side edge of the appliance.
Place the fridge door on the double
door retaining pin.
Remove the top left-hand side door
mount (f) and the panel (c) from the
plastic bag and attach using the
screws (c) (Fig. 1).
Open the fridge door, attach the top
cover (j) using 2 screws (a); at the
same time pay attention to the
repositioning of the magnet (k), then
close the door (Fig. 2).
Put the appliance into position, ensure
it is level and connect to the electrical
supply.
If you do not want to carry out these steps
yourself, please contact your local
Service Force Centre.
The engineer will carry out the door
reversal at your cost.
Fig.4
Remove the left-hand cover pin of the
double door mount (3 pieces, n, k)
and move to the other side (Fig. 3).
Disassemble the door locking
elements (u, v) by unscrewing the
screw (s) (Fig. 3).
Reverse the door locking elements (u,
v), move to the other side of the other
door and fix by screwing in the screw
(s).
Re-insert the stoppers (t, z) on the
other side of the doors.
Fig. 5.
Fit the pin of the double door mount
(m) into the left-hand hole of the
freezer door (Fig. 3).