Setting up and connecting to the, Requirements for the set up location, Electrical connection – Rocktrail Car Cool Box RABB 12 A1 User Manual

Page 52: Gb mt

Advertising
background image

49

Setting up and connecting to the ...

RABB 12 A1

GB
MT

Requirements for the set up location

For the safe and trouble-free operation of the appliance, the following requirements
must be fulfi lled at the installation location:

DANGER

Do not operate the appliance in hot, wet or very humid environments or
close to combustible material, otherwise there will be a risk of a fi re.

In cars, you must locate the appliance so that it cannot hinder or distract
the driver, otherwise there is the risk of an accident.

If securement of the appliance by means of the seat belt is not possible, the
appliance may not be transported in the passenger compartment, instead,
it must be stowed in the boot. Secure the appliance against uncontrolled
movements in the boot also, appropriate to the vehicle type. For this use
suitable straps or netting, so that also in accident situations the appliance
can present no risks to the occupants.

IMPORTANT

If the appliance is not to be used in a motor vehicle, place it on a fi rm, fl at
and level surface.

Locate or mount the appliance such that the extant ventilation openings
cannot be covered, otherwise the appliance could overheat.

You may use the appliance ONLY in vehicles that provide 12V to the
cigar lighter. In passenger cars, the appliance can for example be centrally
placed on the back seat, in so far as there a seat belt available to secure
the appliance. Then, the appliance also serves as a comfortable armrest.

Electrical connection

IMPORTANT

Before you connect the appliance, compare the information about the
required operating voltage on the typeplate with that for the operating
voltage of the intended power source. This data must match, in order to
avoid any damage to the appliance.

Ensure that the connecting cable of the appliance is not damaged and
that it is not laid over hot surfaces and/or sharp edges, otherwise it could
be damaged.

Ensure that the connecting cable is not over-taut or kinked. In cars, the cable
must never be crushed by the vehicle doors, otherwise it will be damaged.

Buch_61537_LB5.indb Abs3:7

Buch_61537_LB5.indb Abs3:7

24.01.12 17:33

24.01.12 17:33

Advertising