Elmo CCD Color Video Camera TNC4604 - Manual (Page 3)

- 2 -
PART NAMES AND FUNCTIONS
1
60 (2.4)
60 (2.4)
3
2
4
90 (3.5)
Lens mount
Mount a CS-mount lens.
Camera mount
For mounting a camera on wall, housing, etc.
(1/4"-20UNC thread)
Focusing dial
For fine-adjustment of the lens back-focus.
IRIS terminal
Connect when an automatic iris lens is used.
VIDEO OUT terminal
Connect to a monitor TV, etc.
(BNC connector)
AC power terminal
Connect this to the AC24V 60Hz or DC12V
power supply.
6
5
4
3
2
1
7
6
5
8
Ground terminal
Connect this to the ground wire of the
power supply cord.
Camera control switches
Refer to "CAMERA CONTROLS" on
page 4.
8
7
+ +
+
1
-
2
+
-
DC12V
AC24V
All dimensions in mm (inch)
HOW TO CONNECT
1. Before connection, make sure that power of all units are OFF and cords are unplugged.
2. Mount a lens onto the camera. Refer to "HOW TO USE" for usable lens.
3. Connect video terminal of the camera and the video input terminal of a monitor TV, etc. with a
75Ω coaxial cable.
4. Connect the power terminal of the camera to a power supply.
Caution: Installation should be made by a qualified service personnel and should conform to all
local codes.
Lens, coaxial cable for video signal and power supply are not supplied with a camera.