Elmo CCD Color Video Camera TNC4604 - Manual (Page 6)

- 5 -
turned on. This is necessary to stabilize the camera against the power noise.
White balance selector
Manual or Automatic white balance modes are selectable. With the setting at AUTO position,
the camera automatically adjusts to the color temperature and adjusts the white balance. The
camera is factory-set at AUTO position. For manual adjustment, set to MANU position and set
the white balance switches as follows.
White balance (WB): According to the combination of the switches 1 and 2, the following
adjustments are available:
IRIS switch
When a DC driven type auto iris lens is used, set this switch to DC position. When a video
feedback type auto iris lens is used, set this switch to VIDEO position.
ALC LEVEL
Adjust video output level, when IRIS switch is DC position.
AES switch (Automatic Electronic Shutter)
With the AGC switch at ON position, AES are available.
By setting the AES switch, Automatic Electronic Shutter mode (1/60~1/10,000 sec) is available.
Note: In electronic shutter mode;
*Sufficient brightness is required.
*The picture will flicker when shooting under the illumination produced by fluorescent lamp.
PUSH button
• Vertical sync. phase adjustment
Vertical sync. phase adjusting is set at the position fully that the delay time of vertical sync.
phase against the phase of power frequency is shortest, when shipped from the factory.
Select this
up ( ) and down ( ) button will make the delay time of vertical sync.
phase against the phase of power frequency longer.
Use the push button
if the picture image on a monitor TV may flow when using the
camera in combination with other camera(s) controlled by the Line-Lock synchronization.
In this case, get a proper image by shifting the phase of vertical sync. signal of the camera
against that of the other. If a proper image cannot be obtained even after this adjustment,
reset the potentiometer to its original position, and use the function control potentiometer
of the other camera to shift the phase of vertical sync. signal of other camera.
Caution: Before making adjustment, make sure that cameras have their power supplies
connected with the same polarity. (not 180° apart)
• Manual white balance selector
When the white balance selector is set to MANU (shift change) in 4 above, the white
balance can be adjusted by using the PUSH switch. This mode will prove effective under
shooting conditions with little variation in color temperture.
* When the white balance selector is set to MANU (shift change), the vertical sync. phase can
not be adjusted.
8
8
8
8
7
6
5
4
1
L
L
H
H
2
L
H
L
H
AWB
* Manual (Shift change)
Manual (Fixed 3200k)
Manual (Fixed 4200k)
*: Can be adjusted by the
PUSH switch.