Tronic KH 3002 - Manual (Page 9)

- 7 -
Note:
Please bear in mind that with a 10 A load the battery
will be exhausted after not more than 45 minutes –
subject to the battery charge condition, even earlier.
Cooler boxes have a typical power consumption of
3 - 4 A per hour. With a battery capacity of 7 Ah,
this corresponds to just under 2 hours of operating
time. You can roughly estimate the operating time
for your appliance using this calculation example.
In this way you can avoid damage caused by
connection errors.
Carrying out connections
Caution!
Ensure that “Positive” and “Negative” are not switched
before connecting your appliance to the Energy
Station. Otherwise your appliance could be
damaged.
You could use the supplied vehicle adapter
 for
supplying power, should its plug fit in the socket of
the appliance.
With the supplied vehicle adapter cable
 the
appliance plug is connected so that Positive is on
the inside and Negative on the outside, as shown.
• You can use the vehicle adapter cable
 if the
socket on the appliance being powered is marked
thus:
• Do not use the vehicle adapter cable
 if the
socket on the appliance being powered is marked
thus:
On appliances with a permanently connected cable
and 12 V plug, “Positive” and “Negative“ have
the correct polarity.
1. Insert the appliance connector of the supplied
vehicle adapter cable
 in the socket on your
appliance.
2. Insert the 12-V plug of the vehicle adapter
,
resp. the appliance being powered, in the
12 V/10 A socket 3 on the Energy Station.
Switching the power supply on
1. Place the main switch 2 at "ON" – your appli-
ance will now be supplied with power.
2. For as long as sufficient energy is available for
the appliance being supplied, the green LED
“Full” 5 is illuminated in the OUTPUT field.
3. When there no longer sufficient energy available
for the appliance being supplied, the red LED
"Empty" 5 is illuminated in the OUTPUT field.
Caution!
You must first recharge the battery when the red LED
“Empty” 5 is illuminated. Otherwise the battery will
be depleted, usually resulting in a considerable loss
of charging capacity.
Ending the supply of electricity
1. Switch the appliance off that is being supplied
with power.
2. Place the main switch 2 of the Energy Station at
"OFF" (centre position).
In this way you prevent current flowing while the
connector is being withdrawn. Sensitive appliances
sometimes malfunction as a consequence.
3. Withdraw the 12-V plug from the 12 V/10 A
socket 3 on the Energy Station and, if need be,
the appliance plug of the vehicle adapter

from the appliance that was being powered.