Ultimate Speed UOP 12 A1 - Manual (Page 10)

7 UOP 12 A1
GB
Pumping oil out
♦ Before starting to pump oil out, let your vehicle engine warm-up for 5 - 10
minutes (oil temperature 40°C - 60°C). This reduces the viscosity of the oil
and it can then be pumped out more effi ciently.
♦ Switch the vehicle motor off .
♦ Roll out the suction hose (Ø 6 mm) 7 and the discharge hose (Ø 12 mm) 8 .
♦ Insert the suction hose (Ø 6 mm) 7 into the dipstick opening of your vehicle.
Insert it carefully down to the lowest point of the oil sump.
♦ Use a suitable container to collect the old oil and insert the discharge hose
(Ø 12 mm)
8 into the container.
♦ Ensure that the on/off switch 2 is in the position 0 (off ).
♦ First, connect the red positive-pole connection terminal (red) 3 to the
positive-pole (+) of the car battery.
♦ Then connect the black negative-pole connection terminal (black) 4 to the
negative-pole (-) of the car battery.
♦ Place the on/off switch 2 at position I (On) to switch the oil suction pump on.
♦ Pump the oil out of the engine/the oil sump.
♦ Place the on/off switch 2 at the position 0 (Off ) when no more oil fl ows
from the engine/the oil sump. Do not leave the oil suction pump running
if it is not pumping oil.
♦ Do not let the oil suction pump run for longer than 30 minutes at a time.
♦ Refi ll the engine with fresh oil as directed in your vehicle manufacturer's
instructions. Check the oil level with the dipstick.
♦ Clean the oil suction pump after the job is done by pumping a little fresh oil
through it.
♦ Dispose of the used oil as per the statutory regulations in your country
(see also the chapter Disposal).
♦ Loosen the hose clamps 9 and remove the suction hose (Ø 6 mm) 7 and
the discharge hose (Ø 12 mm) 8 from the oil suction pump. Store all parts
at a dry, clean and dust-free location.
IB_75715_UOP12A1_LB4.indb 7 IB_75715_UOP12A1_LB4.indb 7 16.09.13 16:39 16.09.13 16:39