Ultimate Speed UOP 12 A1 - Manual (Page 8)

5 UOP 12 A1
GB
■ Use only the supplied connection terminals to connect the device to a car
battery.
■ Keep the connection cable away from hot parts of the engine and do not let
it hang over sharp edges.
■ Route the connection cable so that it cannot be caught up in moving parts of
the engine.
■ Disconnect the connection cable from the car battery when the device will
not be in use for longer periods of time.
■ Keep sources of ignition (e.g. naked fl ames, lighted cigars, cigarettes or
electrical sparks) away from the car battery. There is the risk of an explosion!
■ Avoid causing an electrical short-circuit when connecting the device to the
battery. Connect the positive pole terminal clamp only to the positive pole of
the battery. Connect the negative pole terminal clamp only to the negative
pole of the battery.
■ Connect the terminal clamps ("–" and "+") only to the insulated area!
Initial use
DANGER
► Packaging material should not be used as a play thing. There is a risk of
suff ocation!
Items supplied and transport inspection
▯ Oil suction pump with connecting cable and quick contact connection
terminals
▯ Suction hose Ø 6 mm
▯ Discharge hose Ø 12 mm
▯ 2 x Hose clamps
▯ This operating manual
NOTICE
► Check the contents to ensure everything is available and for signs of visible
damage.
► If the delivery is not complete or is damaged, due to defective packaging or
through transportation, contact the Service Hotline (see chapter Service).
IB_75715_UOP12A1_LB4.indb 5 IB_75715_UOP12A1_LB4.indb 5 16.09.13 16:39 16.09.13 16:39