Sealey S01045 - Manual (Page 2)

3. CONTENT
Recommended hook-up procedure is shown below.
4.1. the saw requires an air pressure of between 50-90psi and an air flow of 6cfm.
4.2. p WARNING! Ensure the air supply is clean and does not exceed 90psi.
too high an air pressure and/or unclean air will result in excessive wear and may be dangerous, causing
damage and/or personal injury.
4.3. Drain the air tank daily. Water in the air line will damage the saw and will invalidate your warranty.
4.4. Clean compressor air inlet filter weekly.
4.5. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). the
minimum hose diameter should be 1/4” I.D. and fittings must have the same inside dimensions.
4.6. Keep hose away from heat, oil and sharp edges. Check hoses for wear and make certain that all
connections are secure.
4.7. Couplings
Vibration may cause failure if a quick-change coupling is connected directly to the air saw. to overcome
this, connect a leader hose (Sealey Part No. AH2R) to the saw. A quick-change coupling may then be used
to connect the leader hose to the air line recoil hose.
4. AIR SUPPLY
5. OPERATING INSTRUCTIONS
p WARNING! Ensure that you read, understand and apply the safety instructions.
NOTE: Numbers in brackets refer to item numbers in the parts diagram and list.
5.1. Loosen the two set screws (24) and adjust, or change, the work guide to suit the job. tighten the set
screws.
5.2. Ensure that your workpiece is properly secured and, if necessary, marked out.
5.3. Start the saw and bring the moving blade onto the workpiece. DO NOT attempt to start the saw with the
stationary blade in contact with the workpiece.
5.4. the maximum blade speed may be regulated by turning the valve screw (1).
5.5. If the cut ends within the sheet material, allow the blade to come to a stop before removing the saw from
the workpiece.
If any item is missing or damaged please contact your supplier immediately.
3 S01045 saw complete with fitted blade and work guide (long)
3 Spare blades
3 Short work guide
3 two hex keys
Original Language Version S01045 Issue: 3 - 15/03/13
© Jack Sealey Limited