Fig.8 fig.9, Maintenance – Sealey SAC12000 User Manual
Page 4
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should
be sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of an environmentally protective way. Contact your
local solid waste authority for recycling information.
Battery Removal
See section 5.2.1. for battery removal
Dispose of batteries according to local authority guidelines.
WARNING: Do not dispose of by fire. This could result in an explosion.
Under the Waste Batteries and Accumulators Regulations 2009,
Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within
these regulations), that they are registered with Valpak’s registered compliance scheme.
Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
.
Original Language Version
SAC120000 Issue: 1- 16/01/15
6.1. General Maintenance.
Turn the unit OFF and disconnect it from the mains power supply before cleaning or
performing any maintenance.
6.1.1. Inspect the unit on a regular basis and replace or repair any damaged parts.
Use recommended parts and an authorised service agent. Unauthorised parts may be
dangerous and will invalidate the warranty.
6.1.2. Do not use any solvents or abrasive material to clean the plastic exterior of the unit. Use only
a damp soft cloth for cleaning and dry the unit afterwards with a clean, dry, soft cloth.
6.2. Air Filters. Clean the air filters every two weeks for optimum performance. The filters are
situated at the rear of the unit (figs.8 and 9), and are held in place by plastic frames.
6.2.1. Upper Filter
Pull the top handle gently to release the holding lugs and remove the filter frame.
6.2.2. Lower Filter.
Pull the corner handle gently to release the holding lugs and remove the filter frame.
6.2.3. Once released, remove the filter from the frame and tap it gently to remove dust, or vacuum
it gently if it is very clogged with dirt.
6.2.4. If the filter is heavily soiled, it can be washed in warm water containing a mild, neutral
detergent. Ensure that the filter is dry completely before installing it.
6.2.5. To replace the filter, first insert the two bottom tags of the filter frame into the bottom edge of
the filter frame recess in the unit. Lay the filter into the filter frame and hinge the frame
forwards into the recess. Push the top of the frame inwards until the two clips snap into place.
6.2.6. Refitting the filter frames into the machine is the opposite of 6.2.1./6.2.2.
6.3. If the unit is not to be used for a long period of time, drain off any water in the tank. Place a
large enough container under the rear of the unit, remove the rubber drainage stopper (fig.7)
to allow the tank to drain. When the tank is empty, replace the stopper firmly. Clean the unit
and air filter as above, and store in a safe, dry area, out of the reach of children.
6. MAINTENANCE
Parts support is available for this product. To obtain parts email [email protected] or phone 01284 757500.
© Jack Sealey Limited
fig.8
fig.9
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business
Park, Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk