Sealey AB2200Q - Manual (Page 2)

New design heaters are up to 50% quieter than traditional forced air models. Two heat settings allow for High and Low output enabling maximum
fuel efficiency. Proven pump system handles paraffin/kerosene or diesel without any modification and provides a cleaner more efficient
combustion. Fitted with top mounted touch pad panel, which allows easy and convenient control over the output and room thermostat
temperature. Fitted with many additional features, including digital room temperature (°C) display, code read out, heavy-duty solid wheels, fuel
tank gauge and heavy-duty filler cap. Suitable for ventilated areas like warehouses, garages and workshops.
 DO NOT touch the heater outlet when in use, or for a period of time after it’s switched off, as these are VERY hot and will take time to cool
down.

DO NOT switch the heater off by disconnecting it from the mains. ALWAYS set the switch on the burner to the ‘OFF’ position and allow the
cooling cycle to finish, before disconnecting from the mains.
 DO NOT use an external fuel tank. Only use the tank that is fitted to the heater, and only fill it when the heater has cooled down.
 Ensure that the heater is correctly turned off.
 When not in use for an extended period, store in a safe, dry area, out of reach of children.
Important: This appliance is not intended for persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that they do not play with the appliance.
 WARNING! This heater is not suitable for use with
Bio-Diesel; use of Bio-Diesel will damage the
filter and seals. Damage caused by use of
Bio-Diesel will not be covered by warranty.
2. INTRODUCTION
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . .AB2200Q
Output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . .50/65kW
Output: . . . . . . . . . . . . . . . . . . . . . . . . . . . . .170,000/220,000Btu/hr
Tank Capacity: . . . . . . . . . . . . . . . . . . . . . . .49ltr
Fuel: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Paraffin/Kerosene/Diesel
Supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . . .230V-5A
Running Time per Filling(Maximum): . . . . . .10hrs
Transport Wheels: . . . . . . . . . . . . . . . . . . . .Yes
Air Flow: . . . . . . . . . . . . . . . . . . . . . . . . . . . .685cfm
Automatic Shut-Off: . . . . . . . . . . . . . . . . . . .Yes
Heated Area:. . . . . . . . . . . . . . . . . . . . . . . . .44000ft³
Heated Area:. . . . . . . . . . . . . . . . . . . . . . . . .1250m³
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37kg
Fig.1
Original Language Version
© Jack Sealey Limited
 DO NOT allow untrained persons to operate the heater and DO NOT operate the heater without the safety guard.
 DO NOT move or handle the heater when hot, without wearing protective gloves. Never move the heater whilst it is operating.
 DO NOT leave the heater unattended for prolonged periods of time when in use. Switch the heater off and unplug from the mains
before leaving work area.
 DO NOT fill the fuel tank whilst the heater is running or still hot. DO NOT over-fill the fuel container. Wipe up any spilt fuel immediately.
 DO NOT obstruct the air inlet (rear) and air outlet (front) of the heater and DO NOT use duct work in front or at the rear of the heater.
 DO NOT allow children or animals near the heater when in use, or whilst still hot.
 WARNING! RISK OF ELECTRIC SHOCK. DO NOT expose the heater to water spray, rain, dripping water or wind.
 DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.
4. ASSEMBLY
4.1. Remove the heater and all the packaging from the carton. Note: make sure the axle is removed from the side of the polystyrene packaging.
4.2. Tools Required: cross head screwdriver, 8mm open ended spanner, 19mm open ended spanner.
4.3. Contents
Fig.2
AB2200Q Issue:2(I) - 19/02/15