Fig.3 fig.4 fig.5 fig.6, Operation – Sealey AB2200Q User Manual
Page 3
4.4.
Refer to fig.2
Insert axle through holes in wheel support.
4.5.
Slide the spacers onto the axle, then slide the wheels onto the axle with the air
valves facing outwards. Use the axle nuts to hold them in place.
4.6.
Refer to fig.3.
Place heater on wheel support frame and line up holes on the fuel tank lip.
4.7.
Attach front handle with four long (55mm) screws and four nuts, through the second and
third holes from the front on both sides of the tank lip and tighten firmly.
4.8.
Insert two short screws (30mm) through the first hole in the front of the front handle and
tank lip. Fit nuts and tighten firmly.
4.9.
Attach rear handle with 4 long screws (55mm) and four nuts through the first and second
hole from the rear on both sides of the tank lip and the wheel support frame and tighten
firmly.
DANGER! Never refuel this heater while it is hot or operating. Fire or explosion could result. Never fill the fuel tank indoors, only outdoors
on a level suface.
DO NOT overfill the tank.
WARNING! Minimum distance from combustibles: Outlet 3 metres, Sides/Top/Rear 2 metres.
5.1. Ventilation
5.1.1. Risk of indoor air pollution and Carbon Monoxide poisoning. Not for indoor use. Indoor use only permitted for the temporary heating of
buildings under construction, alteration or repair.
5.1.2. Always provide a fresh air opening in the heated space. Provide a larger opening if more heaters are being used.
5.1.3.
Minimum Ventilation Opening Needed: AB2200Q - 5990cm² (6.5ft²)
5.2.
Starting the Heater (Ignition) Refer to fig.4
5.2.1. Fill the tank with kerosene or other approved fuel until the needle on the fuel gauge points to "F".
5.2.2. Replace fuel cap and tighten firmly.
5.2.3. Connect the heater to a mains supply. You must use an extension lead that is at least 3 metres long and of a minimum of 14 AWG rating.
5.2.4. Press the power button to turn the heater on.
5.2.5. Select BTU output setting using BTU HI / LO buttons.
5.2.6. Select desired temperature using temperature HI / LO buttons.
5.2.7. The heater will ignite once the temperature setting is higher than the ambient temperature in the space.
Note: If the heater does not ignite, the thermostat may be set too low. Increase the temperature to a higher setting until the heater ignites.
Note: If the heater does not ignite, press power button to turn off the heater, check steps 1-3 above and press power button to power on the
heater. If the heater still does not ignite refer to "Troubleshooting Guide" see section 8.
5.3.
Stopping / Restarting the Heater
5.3.1. To stop the heater, move the power switch to the "Off" position and unplug the mains cable.
5.3.2. To restart the heater wait 10 seconds and follow 5.2. "Starting the Heater" steps.
5. OPERATION
Original Language Version
© Jack Sealey Limited
Fig.3
Fig.4
Fig.5
Fig.6
AB2200Q Issue:2(I) - 19/02/15