Sealey APIBP2100 - Manual (Page 3)

API1500, API1800, API2100 Issue no.1 20/05/10 Original Language Version
5.3 the main clamp is attached to a tube which is a sliding fit
inside the main mounting tube. Withdraw the clamp from the
mounting tube and fix the mounting tube to the two bars 'V',
under the work top using four short bolts as shown in fig.10
5.4 Insert the clamp tube into the mounting tube as shown in
fig.11-Y and rotate the clamp so that it is uppermost. Push the
clamp tube into the mounting tube until the clamp comes up
against the edge of the bench and laps over the top of it as
shown in fig.12.
5.5 Loosen and remove the four bolts on the front of the clamp
and lift the top plate away. Bolt the chosen vice to the top plate
ensuring that the fixings are within the depth of the plate.
Place the vice and plate back onto the top of the bench over
the lower part of the clamp and bolt the two parts back
together again. tighten the clamping knob on the underside of
the clamp assembly. see fig.11-Z.
5.6 to stow the vice under the bench loosen the clamping knob
on the underside of the clamp assembly. see fig.11-Z. Keeping
a firm hold on the assembly pull the vice and top plate
forwards until they are clear of the bench edge. Allow the
assembly to slowly rotate through 180º until it is hanging
downwards. Push the assembly under the front edge of the
bench until it is in the orientation shown in fig.8.
6.1 Drawer units can be purchased as an optional extra. single
and double drawer units can be suspended from the underside
of the bench using two draw support bars as shown in fig.13.
Larger drawer units will be free standing under the bench. see
overleaf for other drawer options.
6. drawer oPtions
fig.14
fig.9
fig.10
fig.11
fig.12
fig.13
aPi8 single draw unit (bench mounted).