Sealey AP3020 - Manual (Page 2)

3.5 Lift the shelf with the legs attached and stand it on to the
upturned bench top so that the legs go between the inner edge of
the bench and the supports and the back edge of the shelf rests
inside the legs already attached to the bench as shown in fig.3.
Ensure that you have adequate help to do this.
3.6 Attach the back edge of the shelf to the rear legs using two sets
of fixings on each leg. These fixings go in the holes furthest
away from the feet. ( See fig. 3.B.)
3.7 Now bolt the front legs to the cross members on the underside
of the bench top. The legs should be on the outside faces of
the cross members as indicated on fig. 3.C. All fixings should be hand
tight at this stage.
3.8 Check that the assembly is correct and then tighten all bolts with
a 17mm spanner before the bench is turned upright.
3.9 Ensure that you have enough help to turn the bench upright
and lift it into its final position. Support the bench whilst gently
tipping it onto its rear face. Now roll the bench onto its four feet
taking care not to let the feet slide as you turn the bench fully
upright.
3.10 To assemble the barrel lock to the draw ( see fig. 1.A ), hook the
the locking arm through the draw front making sure that the lock
is rotated so the flats on the barrel line up with the flats in the hole
and the lock is the right way up so that the arm turns upwards
into the locking position. Refer to fig.1. To fix the lock in place
press firmly on the front of the lock until the two sprung teeth on
the barrel pass through the hole and come to bear on the inside
face of the draw.
3.11 Slide the draw unit fully into the sheet metal runners on the
underside of the bench top ( see fig. 1.B ) and lock the drawer.
Take the bent sheet metal draw retaining plate ( see fig. 1.C ) and
screw it to the back of the draw in the orientation shown in the
drawing. The draw retaining plate will then come to rest on the
back of the bench front edge thus preventing the draw falling out
when it is fully opened.
fig. 3
AP3020 - 1 - 300507
fig. 2
01284 757500
01284 703534 [email protected]
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
www.sealey.co.uk
Web
email
Parts support is available for this product. To obtain parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or phone 01284 757500.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Note! Drawer may be fitted to either left or right-hand pair of
runners.