Sealey AP02DFC - Manual (Page 2)

3.2 BACK ASSEMBLY (Fig.3)
3.2.1 Place the left and right hand back panels on a flat surface, with the flanges facing upwards.
3.2.2 The left hand panel should be placed underneath the right hand panel, aligning the rectangular holes with the tabs on the left hand
panel, carefully slide the two panels together until the screw holes in the back panel have properly aligned.
3.2.3 Use a rubber mallet to tap down the tabs to ensure a tight fit.
3.3 SIDE ASSEMBLY (Fig.4)
3.3.1 Identify the right hand side panel, the door hinges will be at the front with the pins pointing upwards.
3.3.2 Place the panel underneath the back panel and align the tabs with the rectangular holes of the back assembly, slide the two panels
together until the tabs are fully engaged and the top of the side panel is level with the top of the back panel.
3.3.3 Tap down the tabs with a rubber mallet to tighten the engagement.
3.3.4 Repeat the above with the left hand side panel.
3.4 FLOOR ASSEMBLY (Fig.5)
3.4.1 Hold the floor panel at the front and place onto the inside of the of the back panel, align the four tabs into the rectangular holes in the back
panel and slide to engage.
3.4.2 Align the front of the floor with the four screw holes, two holes in each side panel and secure with four M5 x 9mm bolts and M5 nuts.
3.4.3 Secure the back of the floor with one M5 bolt and nut as shown in Fig.5.
3.5 TOP ASSEMBLY (Fig.6)
3.5.1 Attach the top assembly from the back of the cabinet, it will be necessary to lift the back and side assembly slightly to allow the fitment of the
top panel, align the tabs on the top section to drop into the rectangular holes in the tops of the two side panels, slide the top into position so
that tabs fully engage into the holes and the screw holes align.
3.5.2 Secure the top with five M5 x 9mm bolts and M5 nuts as shown in Fig 6.
Fig.2
Fig.3
Fig.4
Fig.5
AP02DFC Issue No: 1 - 06/08/08
Fig.6