Troubleshooting – Sealey 200XTD User Manual
Page 8
9.1
Machine frequently cuts out: (A) The welder is being overworked causing the thermostatic control to activate. (B) May also be due
to a sticking electrode causing the machine to cut out for up to ten minutes. Cut out will automatically reset when welder has cooled.
9.2
Difficulty in striking an arc: a). The electrode is damp. Heat it up to 60º - 70º before using.
b). Wrong type of electrode.
9. TROUBLESHOOTING
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Original Language Version
180XT, 200XTD, 220XTD, 250XTD Issue: 1 - 01/06/12
© Jack Sealey Limited
PROBLEM
CAUSE
SOLUTION
Arc becomes unsteady or is
difficult to strike
1. Input voltage too low
1. Ensure that the power supply is of the required
specification for the welder.
2. Use of a thinner, non standard Welding cable
resulting in too much resistance.
2. Use the correct cable as supplied with the machine.
3. Welding cable quick connector not properly
tightened resulting in excessive resistance.
3 Ensure that cable quick connector is fully inserted
and turned through 180º.
4. Regulation screw and nut worn out.
4. Replace worn parts.
5. Faulty power switch
5. Replace power switch.
Welder overheats and cuts out
1. Welder overloaded
1. Wait for welder to cool down, then operate it within
the requirements of the duty cycle.
2. 220/250XTD, ensure that correct input
voltage is selected for the current welding task.
2. To use 415V the welder must be
connected across two phases of a three phase
supply. If in doubt, consult an electrician
3.Cooling fan broken
3. Repair or replace the cooling fan
Arc will not strike or is difficult to
strike after the welder is switched
on
1. No input voltage from power source
1. Check power source wiring, switch and fuse
2. 220/250XTD, power supply incorrectly
connected
2. To use 415V the welder must be
connected across two phases of a three phase
supply. If in doubt, consult an electrician
3 Partial winding short circuit
3. Return welder to supplier for repair
Cooling fan not working
1. Faulty start up capacitor
1. Replace capacitor
2. Motor burned out
2. Replace motor
3. Faulty wiring
3. Check wiring
For all other problems refer to your local supplier
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email [email protected] or phone 01284 757500.