Sybase 15 User Manual
Page 40
Installing Replication Server
28
Replication Server
The operating system mounts the CD automatically. If you get
CD-reading errors, check your operating system kernel to make sure
the ISO 9660 option is turned on.
Note
If your CD shows up as anything other than sybasecd, it means
you previously installed a Sybase CD on your system. Perform either
of these two options to install your current CD:
•
Restart your system.
•
Delete the sybasecd file in /vol/dsk.
•
HP-UX:
a
Log out.
b
Log in as “root.”
c
Enter the following where device_name is the name of the CD
device drive, and /RS150HP/cdrom is the name of the directory
where the CD is to be mounted:
/etc/mount -F cdfs -o ro device_name /RS150HP/cdrom
d
Log out as “root.”
e
Log in as “sybase.”
•
IBM AIX:
Mount the CD using the following command, where device_name is
the name of the CD device drive, and /RS150IBM/cdrom is the name
of the directory where the CD is to be mounted:
/usr/sbin/mount -v 'cdrfs' -r device_name /RS150IBM/cdrom
The location of the
mount
command is site-specific and may differ
from what is shown in these instructions.
If you cannot mount the CD drive, consult your operating system
documentation or contact your operating system administrator.
3
Verify that you are logged in as the “sybase” user with “root” privileges.
❖
Installing in GUI mode
1
At the UNIX prompt, enter the following, where cdrom is the directory
you specified when mounting the CD drive, and ./setup unloads the
components in GUI mode:
•
IBM AIX: