Sybase 15 - Manual (Page 45)

CHAPTER 2 Installing Replication Server
Installation Guide for UNIX 33
❖ Installing in console mode
The steps for installing components in an interactive text mode are the same as
those described in “Installing in GUI mode” on page 28, except that you
execute InstallShield from the command line using the
setup -console
command, and you enter text to select installation options.
1 At the command line, enter:
• HP-UX and Solaris:
./setup -console
• IBM AIX:
./setup -console -is:javahome JVM
InstallShield starts and displays the welcome window as follows:
--------------------------------------------------
Welcome to the InstallShield Wizard for Sybase
Replication Server Software, Version 15.0.
The InstallShield Wizard will install Replication
Server Software, Version 15.0 on your computer.
To continue, choose Next.
Press 1 for Next, 3 to Cancel or 4 to Redisplay [1]
-------------------------------------------------
2 Follow the remaining prompts to install Replication Server software.
Installing in command line mode
This section discusses the various installation methods available to you from
the command line.
Note If the environment variable $SYBASE is set, the installer uses it as the
default directory for installation. However, you can explicitly specify a
different directory during the installation process to override $SYBASE.