Livarno Z31791A - Manual (Page 9)

9 GB
Before assembly, ensure that the available mains voltage
corresponds to the operating voltage necessary for the light
(230 V ∼ 50 Hz). Otherwise do not install the light bulb.
Only use the under cabinet light set with the included LED
driver, model SB-GTWK6B.
Q
Before assembly
To start with, determine the installation location of the
under cabinet lights.
Then familiarise yourself with the installation and operation
instructions prior to assembly.
The underside of wall units and shelves made from wood
or chipboard are suitable for installation. The installation
frames
6 of the LED spotlights 4 must be installed with
the light pointing down and the flat side right up to the
wall. Please check before installing whether the included
screws are suitable for your wall unit or shelf.
All of the components of this light set must be installed
where they are protected from water and moisture.
The lights and LED driver 2 may not be covered by heat
insulating material. Otherwise there is the risk of overheating.
Ensure that the installation location gives the LED driver
sufficient ventilation. The area temperature of the LED driver
should never exceed 35°C.
To guarantee the flawless functioning of the motion sensor
5 it must be installed at least 25 cm way from glossy
surfaces.
Ensure that the both installation frames for the LED spot-
lights are installed no further than 70 cm apart due to the
length of the connector cable.
Note that the next plug must be reached with the LED driv-
er‘s cable (Length 150 cm). The length of the cable from
the LED driver to the first LED spotlight is 100 cm.
Q
Installation
Note: you will need an electric drill for the installation.
CAUTION! RISK OF INJURY! Please refer to the operating
instructions of your electric drill.
94799_livx_LED-Unterbauleuchten_Model_A_Content_CZ.indd 9 09.10.13 07:39