Livarno 6ER SET 54244 - Manual (Page 9)

English
switching on, malfunctions
Observe all of the instructions and warnings. Improper use or incorrect operation can lead to serious physical injury (e.g. from electric
shock or burning) and substantial material damage (e.g. from fire).
Storage and transport
Store and transport the lamp only in its original packaging. Protect packaged light from mechanical impact, moisture, frost and dust.
Comes with
6x lamps with solar panel, incl. 1x LED + accumulator for each lamp, user manual
Unpacking
Take all the parts of the lamp out of the box and remove the packaging material. Put all the parts of the lamp on a soft surface in front of you, such as a
carpet. Check the parts for any possible visible damage.
Commissioning
1. The decorative solar stone LED lamp can be positioned anywhere as it is not dependent on an external power supply.
However, since the lamp is dependent on solar energy, please note the following points before positioning:
- Choose a location where the solar module is exposed to direct sunlight during the day.
- Avoid choosing a location that is completely or predominantly in the shade (trees, roof ridge etc.).
- At nighttime, the solar module should not constantly be illuminated by other light sources, e.g. by a beam that illuminates a garage driveway. Please
bear in mind that many light sources first switch on in the middle of the night, dependent on time or motion.
2. This lamp has a twilight sensor and an ON/OFF switch. The lamp provides light for approx. 6 to 8 hours when fully charged.
3. Before initial operation, switch the ON/OFF switch on the rear of the lamp to ON and place the LED solar lamp in the sun for.
4. Decorative solar stone LED lamp function:
ON - The decorative solar stone LED lamp automatically switches on when the area starts to get dark. The lamp automatically switches off when the
area starts to get light (If there is sufficient brightness, the battery start to charge)
OFF - The decorative solar stone LED lamp is permanently off.
Disposal of packaging
Dispose of the packaging material, sorting it according to type.
Keep packaging and wrapping away from children. Danger of suffocation!
Damage and malfunctions
LEDs do not light:
Environment too light? Check if light from other sources is hitting the solar lamp. If so, change the location of the lamp. (e.g. street lights or lamps which
are controlled by time or motions)
Battery fully charged? See "Replacing the battery".
LEDs are damaged: The LEDs cannot be replaced.
The light from the LEDs is dim: Battery is not fully charged or damaged; charge the battery in the battery charger or replace with a new battery.
The power fluctuates depending on the time of year: this is due to the weather and is not a fault. The weather conditions in summer are most favorable
and least favorable in winter.
04/2014; IAN94249; 54244 8/27