Epson 400 Series - Manual (Page 45)

Making Detailed Adjustments
45
Other Setup Options
■ Keystone
Adjusts the shape of the image, if the left and right sides are not parallel after tilting the
projector up or down at the screen (see page 25).
■ Projection
Inverts the image for overhead projection.
■ Direct Power On
Sets projection to start when the main power switch is turned on, without pressing the
On button on the remote control or the Power button on the projector.
Note: When direct power on is enabled, power surges that occur after a power outage can
cause the projector to turn on.
■ Video Signal
Leave this setting on Auto so the projector can automatically interpret the format, such as
NTSC or PAL (for standard TV formats).
■ Input A
Change this setting to match the type of equipment connected to the Input A port.
For component video, select Auto to let the projector automatically interpret the signal;
or select YCbCr or YPbPr to manually select your video equipment’s signal.
■ Trigger Out
Turn on this setting if you want the Trigger out port to output a 12-volt signal while
the projector is operating. You can use this to raise or lower your projection screen.
Settings Æ Keystone
Settings Æ Projection
Settings Æ OperationÆ Direct Power On
Settings Æ Input SignalÆ Video Signal
Settings Æ Input SignalÆ Input A
Settings Æ Operation Æ Trigger Out
PowerLite Cinema 400.book Page 45 Friday, July 7, 2006 2:24 PM