Emerson Radio AV400 - Manual (Page 8)

7
Rear Panel
IMPORTANT!
Connect the AC cord only after the speakers, antenna and all optional equipment have been
connected.
Never make or change any connections with the power switched on.
The rating plate is located at the rear panel of the system.
1. FM Antenna Input Connections
For FM reception, connect the FM antenna to the FM jack. Move the antenna in various directions until
the clearest signal is received.
AM Loop Antenna Connections
For AM reception, connect the AM loop antenna to the AM jack. Position the loop antenna to receive the
clearest sound.
Fully insert the stripped portion of the antenna into the terminal as shown above.
Note: Position the antenna as far away as possible from a TV, VCR or other radiation source.
2. Audio Inputs
For connecting audio (Left / Right) input signals from auxiliary sources such as VCR, TV or Satellite
Receiver and playing them through this Home Theater System. These connections are labelled AUX1 and
AUX2 and are selected by the FUNC. button on the front panel.
3. Video Inputs
For connecting video signals from the corresponding video out jacks on the axillary items, such as a TV,
VCR or satellite receiver.
4. Video Output - VCR
For connecting VCR or other recording device (Most DVDs cannot be recorded, however you can use
this connection to record from the auxiliary inputs, such as a satellite receiver, as well).
5. Audio Outputs - VCR
For connecting audio (Left / Right) signals to external recording devices such as VCR or Tape Recorder.
6. Component Video & Progressive Outputs
For connecting TV with component video input (using component video cable, not provided).
1
2
14
7 6 1
13 2 3 5 4 8 10 11 12 9
AC 120V~ 60Hz 200 Watts