Functionality, Start-up, Installation – Livarno 106345-14-01/106345-14-02 User Manual

Page 8

Advertising
background image

8 GB/IE

CaUTIon!
eXPLoSIon hazaRD!

Never throw batteries into fire or water!

Do not exert mechanical strain on batteries!

Do not use non-rechargeable batteries.

Do not short-circuit batteries and / or open
them.

Risk of property damage

Only use the battery type specified!

When inserting the battery ensure the correct
polarity! This is shown inside the battery
compartment!

If necessary, clean the contacts on the
batteries and device before inserting them!

Functionality

The product‘s solar panel converts sunlight into
electrical energy and stores it in two NiMH
batteries.
Switches on the light as it begins to get dark.
The in-built light-emitting diodes are a very long-
life and energy-saving light source. The light du-
ration depends on the amount of sunlight, the
angle of light on the solar panel and the tem-
perature (the battery capacity is temperature-
dependent). A vertical angle of light at temperatures
above the freezing point is ideal. The battery
does not achieve maximum capacity until after
several charge and discharge cycles.

Start-up

Installation

Model 106345-14-01

Assemble the solar light as shown in Fig.
A–E:

Remove the functional unit

1

off the lamp

shade

2

by turning it counter-clockwise

(Fig. B).

Slide the ON / OFF switch

9

to the ON

position to switch it on (Fig. C).

Reattach the functional unit to the lamp
shade and close the connection by turning
clockwise (Fig. B).

Attach the lamp shade to the stand tube

5

(Fig. E).

Use the connector

4

to attach the stand

tube to the ground stake

3

(Fig. E).

Model 106345-14-02

Assemble the solar light as shown in Fig.
F–J:

Remove the bottom splash

6

from the lamp

shade

1

by turning it counter-clockwise

(Fig. H).

Slide the on / OFF switch

2

to the ON

position to switch it on (Fig. H).

Reattach the bottom splash to the lamp
shade and close the connection by turning
clockwise (Fig. H).

To attach the solar light to the ground stake,
insert the ground stake

8

into the opening

on the outside of the bottom splash (Fig. I).

106345_livx_LED-Solar-Gartenleuchten_Modell-D_E_Content_IE_BE_NL.indd 8

14.11.14 12:12

Advertising