Livarno 106345-14-01/106345-14-02 - Manual (Page 9)

9 GB/IE
To float the product in your garden pond,
operate the solar light without the ground
stake
8 (Fig. J).
Installing the light
Using the ground light with the ground
stake
Push the assembled solar light far enough into
the ground (lawn, flower bed) so it is stable.
Make sure it is firmly positioned. Do not use
any force when assembling or setting up the
product, e.g. hammer blows. This will dam-
age the product.
Water use (e.g. garden pond)
(Model 106345-14-02)
Place the assembled solar light on the water
surface without the ground stake
8 installed.
Ensure the bottom splash 6 is at the bottom
(Fig. J).
Do not submerse the solar light in water:
The solar light is only protected from water
so long as the water does not exert pressure
on it.
General information on selecting the
location
For optimal results, place the solar light in a
location where the solar light is exposed to
direct sunlight as long as possible.
Do not position the solar light under shrubs,
trees, porches, etc. This will reduce the inci-
dence of sunlight.
Make sure the solar cell is not impacted by
other light sources, e.g. yard or street lighting,
or the light will not switch on at dusk. In low
light the light will automatically switch on, and
automatically switch off in normal ambient
light.
Replacing the
rechargeable batteries
For optimal performance, the rechargeable
batteries should be replaced every 12 months.
Model 106345-14-01
Remove the functional unit 1 from the lamp
shade 2 by turning counter-clockwise. Then
remove the LED cover 6 from the functional
unit (Fig. B) by turning counter-clockwise.
Slide the ON / OFF switch 9 to the OFF
position to switch the light off (Fig. C).
Open the battery cover 8 and remove the
old batteries. Insert the new rechargeable
batteries (Fig. C).
note: Only use the batteries specified under
„Technical Data“. Please note the polarity
when inserting the batteries. It is indicated
in the battery compartment.
Close the battery cover (Fig. C).
Slide the ON / OFF switch 9 to the ON
position to switch it on (Fig. C).
Reattach the functional unit to the lamp shade
and close the connection by turning clockwise
(Fig. B).
106345_livx_LED-Solar-Gartenleuchten_Modell-D_E_Content_IE_BE_NL.indd 9 14.11.14 12:12