Livarno Z30759 - Manual (Page 23)

23 GB/MT
Safety Information
RISK OF FATAL INJURY!
During installation keep children away from the
area in which you are working. The scope of
supply includes a number of screws and other
small parts. These may prove lifethreatening if
swallowed or inhaled.
J Children or persons who lack the knowledge
or experience to use the device or whose phys-
ical, sensory or intellectual capacities are limit-
ed must never be allowed to use the device
without supervision or instruction by a person
responsible for their safety. Children must never
be allowed to play with the device.
J CAUTION! DANGER OF EX-
PLOSION! Do not operate the
lamp in potentially explosive envi-
ronments in which there are inflam mable
vapours, gases or dusts.
J The light is not suitable for cool
beam halogen bulbs (reduces the
heat load in the light beam).
J This light is designed for use indoors
only, in dry and enclosed rooms.
J The lamp requires no protective
covering to protect against UV radi-
ation or shattering of the lamp
(“self-shielded”).
CAUTION! Only use halogen light bulbs with
a GU 10 base and a maximum output of
230 V~, 40 Watts.
Danger to life by electric shock
J Electrical installation must be performed by a
qualified electrician or a person authorised to
perform electrical installations.
J Every time before connecting the lamp to the
mains, check it and the mains lead for damage.
Dispose the light if you find it is damaged in
any way.
J Before installation, remove the fuse for this cir-
cuit or switch off the circuit breaker (0 setting)
in the fuse box.
J Make sure before installing the light that the
mains voltage at the place of installation com-
plies with the operating voltage of the light
(230 V~) and that the wire cross-section of the
supply cable is not less than 1 mm 2 . Do not
install the light if this is not the case.
J Never let the lamp come into contact with
water or other liquids.
J Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric shock.
Avoiding fire hazards
and risk of injury
CAUTION! RISK OF INJURY! Check the
lamps and light immediately on unpacking for
signs of damage. Do not install the light if you
discover any damage.
RISK OF ELECTRIC SHOCK!
RISK OF DAMAGE TO PROPERTY! RISK
OF INJURY! Ensure that you do not strike
electrical cables, gas or water pipes when you
are drilling into the ceiling. If necessary, check the
ceiling using a suitable detector before you drill.
J
0.5 m
FIRE HAZARD! Fit the light so that
it is at least 0.5 m away from the
material illuminated. Fire can result
from the development of too much heat.
CAUTION! RISK OF BURNS! Make sure
that the light is switched off and has cooled down
before you touch it. Lamps can become very hot.
Correct procedure
J Check before fastening the light to the ceiling
whether the ceiling is suitable for supporting
the light. If necessary seek advice from your lo-
cal DIY supplier or a construction professional.
J Examine the ceiling before installation and
choose suitable installation fixings.
J For ceiling installation we have supplied fixings
suitable for ordinary solid concrete or masonry
construction.
J Replace defective bulbs with new ones immediate-
ly, otherwise damage to the product may occur.
J Only use 230 V~ halogen light bulbs with a
GU 10 base and a maximum output of 40 Watts.