Livarno Z30697 - Manual (Page 10)

10 GB/IE
10 GB/IE

Installation Installation
note: Before you start work make
yourself familiar with each step of the
installation, otherwise have the product
installed by electrician.
note: The floor light must be installed
only in areas to which there is limited
access (e.g. footway edge / path). The
floor light is adequately anchored only
when installed in a concrete substrate.
Therefore, in the case of installation in
soil or in wooden substrates, you should
ensure that the floor light is not placed
in areas that are accessed by vehicles
(e.g. parking spaces, vehicle drives) or
on which you use garden equipment
(e.g. snow clearers). Failure to observe
this advice could result in the floor light
being lifted out of the substrate and pos-
sible damage to the product and/or
injury.
note: The batteries have been prein-
stalled in your device at the factory.
note: Ensure that the light is installed
so that the solar cell
7 is exposed to
direct sunlight.
note: You have the choice of installing
the light in the ground or in a substrate
such as wood (e.g. patio) or concrete.
Installation in a wooden or concrete
floor requires a drill and hole cutter suit-
able for use on wood respectively.
note: To do this you will require a
Phillips screwdriver and an Allen key.
CaUTIOn! rISK OF InJUrY!
Consult the drill manufacturer‘s operating
manual before you use your drill.
CaUTIOn! rISK OF InJUrY!
Before installing the product, ensure that
there are no water pipes or electrical
wiring in or under the ground or sub-
strate.