Livarno 103792-14-01-BS/103792-14-02-BS - Manual (Page 8)

8 GB/IE/CY
Bringing into use / Maintenance and Cleaning
Q
Bringing into use
Never direct the LED light beam on
to reflective surfaces or at people
or animals. Failure to observe this
advice may result in eye injury
and / or loss of sight to people or
animals. Even a weak LED light
beam can cause eye damage.
Attach the lamp in the desired posi-
tion by means of the clamp
2 .
CAUTION! RISK OF
SHEARING OR
CRUSHING INJURY!
A large force is required to attach
the lamp. This could result in a risk
of shearing or crushing injury through
trapping parts of your body.
Connect the mains connector 5 to
the mains adapter 6 .
Insert the mains adapter 6 into an
ordinary domestic mains outlet
socket (230–240 V~).
Use the ON / OFF switch 3 to
switch the lamp on or off.
Bend the flexible lamp arm 1 to
bring the lamp into the desired po-
sition.
Note: Do not turn the flexible lamp
arm
1 completely about itself or
the mains lead inside the lamp could
be damaged.
Q
Maintenance
and Cleaning
Note: The device requires no mainte-
nance. The LEDs cannot be replaced.
Do not use any solvents, petrol or
similar. This would cause damage
to the light.
Pull the mains adapter 6 out of
the mains socket.
CAUTION! DANGER OF ELEC-
TRIC SHOCK! For electrical safety
reasons do not clean the lamp with
water or other liquids and never im-
merse it in water.
Always use a dry fluff-free cloth for
cleaning the device.
Never direct the LED light beam on
to reflective surfaces or at people
or animals. Failure to observe this
advice may result in eye injury and /
or loss of sight to people or animals.
Even a weak LED light beam can
cause eye damage.
103792_A-B_LED-Klemmleuchte_Content_BS_GB_IE.indd 8 09.10.14 10:51