Emerson SB280 - Manual (Page 5)

4
POWER SOURCES
This unit is designed to operate 8 “C” batteries, not included, or on normal 120V
60Hz AC house current. Operating this unit from any other power source may
cause damage to the unit, and such damage is not
covered by your warranty.
Battery Operation
1.) Remove the battery compartment door on the
bottom of the cabinet by pressing down on the
“Arrow” symbol and sliding the door in the direction
of the arrow.
2.) Insert 8 “C” size batteries into the battery
compartment according to the polarity diagram
engraved inside the compartment. If the batteries
are inserted incorrectly the unit will not work.
3.) Replace the battery compartment door.
PREPARATION FOR USE
UNPACKING AND SET UP
·Carefully remove the unit from the carton and remove all packing materials from
the unit.
·Carefully remove any small strips of tape which may have been used to keep
the CD and Cassette doors closed during shipment.
·Open the CD compartment by placing you finger under the notch on the front of
the CD door and lifting upward. Inside the CD compartment you will see a white
transit card which is used to prevent the laser pick-up from moving during
shipment. Carefully remove this card and close the CD compartment door.
·Please save the carton and packing materials in the event that your unit ever
needs to be returned for service. The original carton and packing materials are
the only way to protect the unit from damage during shipment.
SB280_033104.p65 31/3/2004, 10:45 4