Livarno KH 4112 - Manual (Page 6)

- 4 -
6. Select a suitable
installation site
Always place the table lamp on a solid, level, slip-
proof surface.
To avoid malfunctioning, do not place the table
lamp on metallic surfaces.
Do not place any easily inflammable/combustible
materials in the immediate vicinity of the table lamp
while it is switched on. Do not cover the table lamp
while it is switched on. Also, do not hang any ob-
jects over the table lamp.
Do not place the table lamp on metallic objects.
Otherwise there is a risk of a
short-circuit or fire!
7. Preparing the table lamp
for use
1. Carefully remove the table lamp from the packa-
ging.
2. KH 4112/KH 4114: Screw the light bulb 1
(not supplied) into the bulb holder 3. Thereby,
do not touch the bulb with your bare hands, in-
stead, use a soft and lint-free cloth.
3. KH 4113: Loosen the covering cap 6 from the
table lamp. Carefully remove the lampshade 2
upwards from the table lamp. Screw the bulb 1
(not supplied) into the bulb socket 3. Replace
the lampshade 2 back onto the table lamp. Se-
cure it with the help of the covering cap 6.
4. Applies to all models: Unwind the power cable
5 to its full length. Insert the power cable 5
into a power plug.
The table lamp is now ready for use.
8. Using the table lamp
• Switch the table lamp on by touching the base 4
with a finger (KH4113: touch the base 4 or the
stand).The table lamp now lights up at the lowest
brightness level.
• To switch it to the second brightness level: touch
the base 4 a second time. Thereby, do not touch
the bulb with your bare hands, instead, use a soft
and lint-free cloth.
• To switch it on to the third brightness level: Touch
the base 4 once again.
• To switch the table lamp off: touch the base 4
once again.
If you do not wish to use the table lamp for an ex-
tended period of time: Remove the power cable 5
from the power socket. To avoid damage, be care-
ful not to kink the power 5 cable.
9. Changing the light bulb
Should the bulb 1 in the table lamp be defect, it
must be exchanged for a new one. Additionally:
• Remove the power cable 5 of the table lamp
from the power socket.
If the table lamp was previously switched on: Allow
the lamp shade 2 and the light bulb 1 at least a
half-hour to cool down before you continue.
The risk of burns is ever present!
• KH 4112/KH 4114: Screw the light bulb 1 out
of the bulb holder 3 in an anti-clockwise direction.
• KH 4113: Loosen the covering cap 6. Careful-
ly remove the lampshade 2 upwards from the
table lamp. Then screw the old light bulb 1 out
of the bulb holder 3.
IB_64705_KH4112_14_LB4 26.04.2011 9:45 Uhr Seite 4