Enterasys Networks ANG-1000 - Manual (Page 22)

10
Aurorean Network Gateway-1000 User’s Guide
Checking ANG-1000 Connections Chapter 2
Installation
Figure 11 ANG-1000 Front Panel
After the ANG-1000 is configured and in use, the Internet, VPN, RX and TX
LEDs will light and/or blink. Refer to Figure 12 for behavior of the LEDs.
The ANG-1000 is now ready for configuration. Refer to Chapter 3 for detailed
instructions.
Figure 12 ANG-1000 Front Panel LEDs
NOTE
COM1 and COM2 LEDS are not operational at this time.
Power On when ANG is powered up
Active
Internet On when External network is assigned an IP address
VPN On when a tunnel is connected
TX Blinks when data is transmitted
RX Blinks when data is received
Blinks when CPU is active