Livarno 2772-012L or 2777-012L - Manual (Page 12)

12 GB
Safety / Start-up / Maintenance and Cleaning
The light can not be repaired. If the light or the
power cord (secondary cord) is damaged, the
product must be replaced.
Never let the lamp come into contact with water
or other liquids.
Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric
shock.
To avoid danger of
fire and injury
RISK OF INJURY! Before using the light
bulb always check it for damage. Do not use
the light with a faulty light bulb.
Check the light regularly and before every use
to see if there is any damage to the casing and
mains plug. Never use the light if it shows any
signs of damage.
RISK OF INJURY FROM BURNS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Bulbs give off a lot
of heat around the top of the lamp.
Do not allow the lamp or the packaging mate-
rials to lie around unattended. Plastic film or
bags, Styrofoam etc. can turn into dangerous
toys for children.
Do not look directly into the light source (light
bulb, LED etc.).
The light is not suitable for clipping to tubes.
The lamp is not replaceable.
This light is not suitable for external dimmers or
electronic switches.
In order to disconnect the light completely from
the power supply, the light must be removed
from the socket.
Safe working
Use the light in a way where in it protected
from moisture and dirt.
Remain alert at all times and always watch
what you are doing. Always proceed with
caution and do not assemble the lamp if you
cannot concentrate or feel unwell.
Please familiarise yourself with all the instructions
and diagrams in this manual and with the lamp
itself before using it.
Dispose of the lamp if the lamp glass 1 is
broken or cracked.
This article is a wall or reading light. Do not
use it as a nightlight.
Start-up
2772-012L
Clip the light on in a suitable location.
Plug the power cable and power plug 5 into
the socket.
Press the ON/OFF line switch 4 to switch the
light on or off.
2777-012L
Screw the light down in a suitable location.
Plug the power cable and power plug 5 into
the socket.
Press the ON/OFF line switch 4 to switch the
light on or off.
Bend the flexible lamp arm 3 into the desired
position using the lamp pin 2 .
Note: Do not turn the flexible lamp arm 3
completely about itself. Otherwise the mains
lead inside the lamp could be damaged.
Maintenance and Cleaning
CAUTION! RISK OF ELECTRIC SHOCK!
First of all pull the lamp out of the mains socket.
For electrical safety, never clean the light with
water or other fluids, or immerse it in water.
Note:
The device requires no maintenance. The
lighting set cannot be replaced.
Do not use any solvents, petrol or similar. This
would cause damage to the light.
Allow the lamp to cool down completely.
When cleaning, only use a dry, lint-free cloth.