ELAN Home Systems GR2000 - Manual (Page 16)

Routing Software 06-02 (OS3) Installation Guide
6 S-9181-31X
2.3 Update Procedure 3
This update procedure is for a GR2000 that is configured from two RMs, each using
two MCs. It updates the backup and current MC cards, both with an old version of
software stored in them for individual RMs of the active and standby systems. After
the update procedure for the current MC is complete, the GR2000 automatically
restarts. Upon restart, communication is interrupted temporarily. Do not pull out
and insert an MC card while updating the software.
1. Log into a GR2000 with a user ID that the user has set (for example, operator).
2. Enter an admin command. The command prompt changes to DGPLQ .
3. Execute a version command to check that the version in current use is one of
software versions from which the update is allowed as listed in Table 2-3.
4. Execute an information router command to check that individual capacities of free
space in MC0’s and MC1’s of rm0 and rm1 are equal to or larger than the
capacity listed in Table 2-3.
5. Execute a synchronize –s secondary command, a synchronize –s standby:primary
command, and a synchronize –s standby:secondary command to check that the
current MC of the active system is identical to the backup MC of the active
system, and also that the MCs of the standby systems in the configuration
definition, the password file, and the user account are identical. If not identical,
execute a synchronize –a secondary command, a synchronize –a standby:primary
command, and a synchronize –a standby:secondary command to make them
identical to each other.
6. Using FTP, transfer the files listed in Table 2-1 to a place under the /primaryMC/
usr/var/update directory in the GR2000 by the file name of 83'$7(WJ] (be sure to
transfer in the binary mode).
7. Execute a ls –l /primaryMC/usr/var/update command to check that the size of
transferred files is the same as the size of files in the CD-ROM individually.
8. Enter a cd /primaryMC/usr/var/update to move to the relevant directory.
9. Execute a ppupdate UPDATE.tgz secondary standby command to update the backup
MC in the RM of the standby system.
10. Execute a ppupdate UPDATE.tgz primary standby command to update the current
MC in the RM of the standby system.
11. After the update procedure for the current MC in the RM of the standby system is
complete, the RM of the standby system automatically restarts.
12. Execute a ppupdate UPDATE.tgz secondary act command to update the backup MC
in the RM of the active system.
13. Execute a ppupdate UPDATE.tgz primary act command to update the backup MC in
the RM of the active system.
14. After completing the update, the message 5HERRW DFWLYH 50 DIWHU  VHFRQGV is
displayed, and the GR2000 automatically restarts 30 seconds later.
15. The update of the MCs is now complete. After the GR2000 restarts, log in again
and execute a version command to check that the GR2000 is operating with the
new version.