Everpure H-300 - Manual (Page 6)

EN
G
LI
SH
• 6 •
Systems Tested and Certified by NSF International
against NSF/ANSI Standards 42 and 53 for the
reduction of claims specified on the Performance
Data Sheet.
VERIFy UNDER-SINk MOUNTING LOCATION
Measure 22” from the base of the cabinet, and mark the
mounting location for the top of the filter head. Measure 13” for
the width required for the H 1200 System with dual cartridges.
Make sure there is adequate space above the head to open
and close the shut-off valve and to avoid crimping the water
line tubing. Also, make sure your chosen location offers easy
access for future cartridge changes.
DIMENSION Width Height Depth
H-1200 13" 22" 5"
NOTE: The head and cartridge must be mounted in the vertical
position, with the cartridge hanging down.
MOUNT FILTER HEAD UNDER SINk
Identify Dual Filter Head and Shut Off Valve (EV3098-
60).
Apply Teflon Tape to the threads on the inlet (left) side
of the Head. Screw on the new Shut Off Valve and hand
tighten. Repeat for the Stainless Coupler (EV3123-50) for
the outlet (right) side of the Head.
Apply Teflon Tape to the threads of the Outlet Elbow
Fitting (black band). Screw into the outlet of the
Stainless Coupler. Wrap tape in direction of the threads
to assure a tight fit and avoid small leaks.
Securely mount the filter head on the cabinet wall using
the enclosed mounting screws and washers.
Go to page 2 and follow Basic Installation Instructions,
Steps 4, 5, and 6, to complete the H-1200 System installa-
tion.
2.
3.
A.
B.
C.
D.
4.
CLAIMS & NOTES
This installation must comply with all applicable state and local
regulations.
Do no use with water that is microbiologically unsafe or
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on waters that may contain filterable cysts.
Testing was performed under standard laboratory conditions,
actual performance may vary.
3
A
D
Dual Filter Head Shut Off Valve
C
B
2
22 "