Safety / preparation, Preparation, Preparing the remote control – Silvercrest WIRELESS SOCKET SET User Manual
Page 39: Synchronise the system code, Inputting the system code into the remote control
39
GB
Safety / Preparation
Remove spent batteries immediately
from the device.
Preparation
Before using these devices you must
insert the batteries,
synchronise the system code for the
remote control
1
and the remote
controlled socket
7
using the DIP
switch
6
,
10
and
allocate a ON/OFF button pair
4
,
3
on the remote control
1
to a
remote controlled socket
7
.
Preparing the remote
control
Open the battery compartment on
the back of the remote control
1
by pushing away the battery com-
partment cover
5
downwards and
then up.
Insert two enclosed batteries AAA.
Press one of the ON/OFF buttons
4
,
3
to test whether the remote
control
1
works. If it does, the
power indicator light
2
will come
on. If this light is not lit then the
device is not receiving any energy
from the batteries. Check if the
batteries are in the right way.
Close the battery compartment.
Synchronise the
system code
To use this device for the first time the sys-
tem code must be synchronised by using
the DIP switch
6
,
10
in order for all
the remote controlled sockets
7
to react
to the remote control‘s
1
radio signal.
Each remote controlled socket
7
must be
assigned to a button pair on the remote
control
1
so that each remote controlled
socket
7
can be operated separately.
Note: Change the position of the DIP
switch
6
,
10
with a suitable item, e.g.
a small screw driver with which the DIP
switch
6
,
10
can be push upwards or
downwards.
Inputting the system
code into the remote
control
Open the battery compartment on
the back of the remote control
1
by pushing away the battery com-
partment cover
5
downwards and
then up.
With the DIP switch
6
put in any
system code with the number 1 to 5.
Close the battery compartment.
Inputting the system
code into the remote
controlled socket
Turn the screws
12
of the cover
11
with a crosshead screw driver size
PH0.